When a series is opened, its ﬁrst image is displayed in the series window.
The window for viewing series is shown in Fig. 2.7.
On the right-hand side of the window, you can see a scroll bar for scrolling images of the series (marked by the green arrow). If the series contains several phases or is a multiframe series, at the top of the window you will see an additional scroll bar (marked by the red arrow) for switching between phases or frames. In the window, you will ﬁnd the information on the current image (see Section 2.27).
There are six ways to switch to other images:
Roll the mouse wheel up to switch to the previous image or down to go to the next one. One click of the wheel changes the position by one image.
Use the scrollbar on the right side of the series window to move to the target image. To change the position by one image, click the left mouse button on the arrow or the bar above or below the scroll.
Click the left mouse button holding the Shift key. If the current image is the last in the series, a click will switch you to the ﬁrst image. Similarly, click the left mouse button holding the Ctrl key to move to the previous image.
Use the Scrolling tool. Activate the tool on the toolbar by clicking the left/right/middle mouse button. To continue work with this tool, use the button with which the tool was activated. To learn more about tool control, see Section 1.14.
If it is impossible to switch between images, the tool may be used for scrolling frames.
Use the arrow buttons on the toolbar: , .
Use the context menu: right-click the mouse on the image and select Next image or Previous image.