Contents

Inobitec DICOM Viewer

1.3. Tab Panel

1.3.1 General

A tab is a window ﬁxed in the main program window. You can switch from tab to tab using buttons on the tab panel. The tab panel is highlighted in red in Fig. 1.4.

Figure 1.4: Tab panel location in the DICOM Viewer window

Each tab opened in the DICOM Viewer window corresponds to a stub on the panel. To switch to a particular tab, click the corresponding stub (Fig. 1.5). The ﬁle path or other information about the tab content is displayed on the tab stub.

Figure 1.5: Multiple tabs. The Image viewer tab is active

To show the patient’s name on the tab stub, enable the Show patient name in a tab option in the program settings (see Section 16.2). This option is enabled by default. In the ﬁgure, you can see the type of the tab shown only as an icon on the left-hand side of the patient’s name (Fig. 1.6).

Figure 1.6: Patient names are displayed on the tab stubs. The Image viewer tab is active

If several studies have been opened in the same tab, the patients’ names will be separated with "/". If a patient’s name is too long, it will be truncated and the "…" sign will be placed at the end, e.g. Patient name.../ Patient name.../ Patient name...

If there are fewer than 5 symbols left for each patient’s name, then the tab will only show the name of the ﬁrst patient and the number of the patients’ names left, e.g. Patient name…+4.

When you place the cursor on the tab stub, a tip with a complete list of the patients’ names will pop up.

On the stub of a fused series tab, you will see the name of the patient from the ﬁrst layer.

1.3.2 Manage a Tab

To manage a tab, use the buttons in its top right-hand corner (highlighted in red in Fig. 1.7).

Figure 1.7: Tab management buttons

Tab management buttons:

	The Full screen button displays the tab in the full screen mode. The tab management buttons are unavailable. To exit, press Esc or F11.
	The Separate window button displays the tab in a separate window.

To switch to the full screen mode, you may as well press F11, and to go back, you can use F11 or Esc. If the tab is displayed in a separate window, the DICOM Viewer workspace looks as shown in Fig. 1.8.

Figure 1.8: A tab opened in a separate window

The window management buttons are located in the top right-hand corner of the window (highlighted in red in Fig. 1.8). Window management buttons:

	The Fix window button embeds the window as a tab in the main DICOM Viewer window.
	The Full screen button displays the window in the full screen mode. The window management buttons are unavailable. To exit the full screen mode, press Esc or F11.
	The Minimize window button reduces the window to an icon located at the bottom of the screen (highlighted in red in Fig. 1.9). The window title is written on the icon.
	The Expand button expands the window to the full screen. Unlike the full screen mode, the window management buttons will be available.
	The Close button closes the window.
	The Restore down button restores the initial window size.

Figure 1.9: Window reduced to an icon

To unfold a window from an icon, double-click the left mouse button on the icon.