____________________________________________________________________________________________
Functionality is available in a separate module which is activated in the Pro edition for an extra fee
____________________________________________________________________________________________
____________________________________________________________________________________________
Functionality is available in a separate module which is activated in the Pro edition for an extra fee
____________________________________________________________________________________________
The PET analysis tab may contain 1-6 image viewing windows:
The mode may be changed by pressing the respective button on the toolbar. The button will look different depending on the current mode:
![]() |
3D MIP mode. The mode may be switched to Mono PET |
![]() |
Mono-PET mode. The mode may be switched to 3D MIP |
![]() |
Mono-KT mode |
![]() |
Fusion PET+KT mode. The mode may be switched to Mono CT |
To switch the mode, activate the respective window by left-clicking on it, click the mode button and choose the mode you need from the menu. The current mode is highlighted in blue. The procedure of setting the template for each mode is described in Section 8.2.2.
On the left, you can see the Series List panel showing all the series for the study. To open the required series in the PET Analysis window, drag it into the window. The MIP window may only be used for PET series, but you can drag PET, CT or fused series to other windows.
Double-click any of the four windows with the left mouse button to unfold it. Please, note that you shouldn‘t activate any of the measuring tools, annotation tools or the magnifier with the left mouse button.
____________________________________________________________________________________________
Functionality is available in a separate module which is activated in the Pro edition for an extra fee
____________________________________________________________________________________________
To set the windows arrangement templates, click the mode selection button ( ,
,
or
depending on the mode) and select Options... A dialog box shown in Fig. 8.2 will
pop up.
Choose a template from the drop-down menu (One, Two near, 2x2, 2x3).
To use this template as default, tick the Use current template as default box.
To set a template window, select this window with the mouse. It will be highlighted (in Fig. 8.2 the upper left window is selected). Then proceed as follows:
To restore the default settings for the current template, click the Default button. In the dialog box that pops up, press Yes to restore the settings or No to cancel. By default, the following template settings are provided:
Press OK to apply the settings or Cancel to cancel the operation.
The changes in the template do not affect the tabs that had been opened before such changes were introduced.