Figure 10.2: Toolbar
____________________________________________________________________________________________
Functionality is available in the Pro edition
____________________________________________________________________________________________
The toolbar is displayed in the top left part of the tab (Fig. 10.2).
The MPR navigation panel is on the right side of the tab.
The view setup panel is in the top right part of the tab (Fig. 10.3).
Once you start auto-moving (see Section 10.3.1), the cavity surface sweep will appear at the bottom of the window (Fig. 10.4).
 | Cavity surface sweep should only be used for navigation purposes. You cannot make a diagnosis on its basis. To establish a diagnosis, open the respective series in the Image Viewer window. |
____________________________________________________________________________________________
Functionality is available in the Pro edition
____________________________________________________________________________________________
The MPR (multiplanar reconstruction) panel consists of three parts, each displaying a body section by one of the three orthogonal planes.
To hide/display the MPR navigation panel, click the MPR navigation 
button on the
toolbar.
To change the panel size, move its border. To do this, move the cursor to the panel
border so that it would look like this: 
, and drag the border holding the left mouse
button.
To change the size of the panel parts displaying the sections by various planes, move the borders dividing the panel parts.
